US Blaster USB 7392 Benutzerhandbuch Seite 12

USB 7392 - 7393
Microphone systems
SETTING UP YOUR HANDHELD TRANSMITTER (WIRELESS MICROPHONE)
To change frequency / channel press "SET" until the LCD screen displays CH001 *(channel
display values) or 750.000*(frequency display values) (*varies depends on current settings). Press the up
or down buttons to select a different channel/frequency (channel ranges from 1-99). Then the LCD screen
will flash. Press "SET" again to confirm (if you don't confirm, no adjustments will be made.)
NOTE: Match your frequency / channel to the receiver's. The RF indicator on the receiver will show a sig-
nal.
TO CHANGE DISPLAY BETWEEN FREQUENCY/CHANNEL:
"FREQUENCY" displays the frequency signal's actual units, while channel displays a substitute letter or
number.
Keep pressing set until LCD screen displays "DISPLAY". After 1-2 seconds the screen will show FYE 9 u (for
frequency) or CHAnnl (for channel). Note: Current display depends on settings. Press the up or down but-
ton to switch between the two. Then the LCD screen will flash. Press "SET" again to confirm (if you don't
confirm no adjustments will be made.)
TO UNLOCK/LOCK YOUR SETTINGS:
NOTE: In lock mode settings can not be adjusted and transmitter can not be powered off, in unlock mode
all settings can be adjusted.
Keep pressing set until LCD screen displays "LOC SET" after 1-2 seconds the screen will display Loc OFF
(unlock) or Loc ON (locked). Press up or down to switch between the two settings. Then the LCD screen
will flash. Press "SET" again to confirm (if you don't confirm no adjustments will be made.)
© US Blaster Europe BV