Installer Setting-Static Pressure Setting - LG PQRCUSA0 Bedienungsanleitung

Installer Setting -Static Pressure Setting
This function is applied to only duct type. Setting this in other cases will cause malfunction.
<Static Pressure Setting Table>
Pressure selection
01 F-L
02 F-H
03 V-L
04 V-H
1
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2 Repeat pressing
Function code 06.
Function Code
3
Select static pressure by pressing
button.
(01:V-H, 02:F-H, 03:V-L, 04:F-L)
4
Press button to save or
release.
5 Press button to exit or
system will automatically exit
after 25 seconds without any
input.
Function
Zone state
Fixed
Fixed
Variable
Variable
Owner's & Installation Manual 17
Installation instruction
button to select
Pressure
ESP standard value
Low
High
Low
High