Installer Setting-Thermistor - LG PQRCUSA0 Bedienungsanleitung

Installer Setting -Thermistor
Therefore system will use value that sensed from indoor unit or remote controller
<Thermistor Table>
Temperature sensor location
01 Indoor unit
02 Remote controller
03 2-Thermistor(2TH)
1 Press
to enter the installer setting
mode until timer segment
display "01:01".
2 Repeat pressing
Function code 04.
Ex) Setting Thermistor as '2TH'.
3 Set Thermistor mode by pressing
button. (01: Remote Controller,
02: Indoor, 03: 2TH)
4 Press
5 Press
system will automatically exit
after 25 seconds without any
input.
Operation in indoor unit temperature sensor
Operation in remote controller Temperature sensor
Operation in lower temperature after comparing the temperature between
the indoor unit and remote controller
Owner's & Installation Manual 15
Installation instruction
button for 4 seconds
button to select
Function Code Thermistor setting
button to save or release.
button to exit or
Function