Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The same way the child lock is activated, it can also get deactivated. After
pressing
until the beep, then the
and
have to be pressed
simultaneously for at least 0,5 sec, followed by touching only the
. As
a confirmation for successful unlocking, ´L` symbol in the displays will be
erased immediately.
Stop & Go Function (available only in some models)
The Stop & Go functionality can be used only alternatively to Key lock
functionality. It is not possible to use both.
The Stop & Go function is activated by pressing
for 1 sec. Afterwards
it is acknowledged acoustically by two beeps.
The Stop-function is active and all heaters which are turned on will be
reduced to heat setting ´1` for 1 minute, then for the remaining 9 minutes
a running light with a horizontal bar starting from the bottom to the top is
displayed. Afterwards all heaters are reduced to heat setting „0“ for the rest
of the time. For all inactive heat settings, there is ´0` or the residual heat
´H` indicated.
The heater completely turns off after 10 minutes or after immediate operation
of
.
If the heater is turned off via
, the heater is in S-Mode and the Stop-
function is deleted. If the heater is turned on again, there is no Stop & Go
function.
18
Werbung
Kapitel
Inhaltsverzeichnis
