Herunterladen Inhalt Inhalt Diese Seite drucken

Turn On Dual- And Triple Zones; Set Cooking Level With And Without Heat Boost - Nordmende HCT62FL Bedienungs- Und Installationsanleitung

Glaskeramik-einbauherd
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Turn on dual and triple zones (available only in some models)
Turn on the dual zone
The activation of the dual zone is done after selecting the desired heater
by actuating
. This is confirmed by a buzzer signal. At the same time, the
corresponding Dual Zone Indicator goes on statically. Touching
for a
second time, the status of the dual zone toggles: it changes from dual zone
on to dual zone off and back again.
The extension zone can be activated only, after a level between 1-9 is set
on the basic zone of the heater.
Turn on triple zones
A dual or triple zone can only be switched on, if the basic zone of a heater
is set to level 1–9 and the heater is selected, the dot is on.
If
is pressed, the buzzer signal sounds and the Dual Zone Indicator is
statically on. If
is pressed once again, there is another acoustical signal
and the triple heater is switched on. The Triple Zone Indicator will be
illuminated and the triple zone will be energized.
After touching
once again, the triple zone of the heater will be switched
off again. Each operation causes a status change of the dual/triple zones
following in this manner (Dual zone on, triple zone on, all extended zones
off, dual zone on, triple zone on, dual zone on, etc.)

Set Cooking Level With and Without Heat Boost

All heaters are equipped with heat boost functionality.
If the heat boost is active, than the heater will be operated with maximum
power for the period of the heat boost time, that is dependent from the
selected heat setting. This is indicated through a flashing ´A`, alternating
with the heat setting value (e.g. 0,5 sec ´A` and 0,5 sec ´9`) in the heater
display. Once the heat boost time ended only the heat setting will be indicated.
If the heat boost should be used for a heater, heater level 9 must be operated
by pressing
starting from level 0. After setting the heat to level 9 , ´A`
will be indicated alternating. This means that level 9 and heat boost is active
now.
12

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis