Basic Operations; Handset Settings - Yealink CP930W-Base Schnellstartanleitung

Network Settings
You can configure the base station to obtain network settings in one of the following ways:
DHCP
By default, the base station attempts to contact a DHCP server in your network to obtain the val-
id network settings, such as IP address, subnet mask, gateway address and DNS address.
Static
If the base station cannot contact a DHCP server for any reason, you need to configure the IP
address, subnet mask, gateway address, primary DNS address and secondary DNS address for
the base station manually.
To configure the network parameters for the base station manually:
1. Tap Menu->Settings->Advanced Settings (default PIN: 0000)->Network->Basic.
2. Select the desired IP addressing mode from the IP Mode field.
3. Select the desired IP addressing mode.
4. Make the desired changes.
5. Tap the Save soft key to accept the change.
Note:
• The DECT conference phone supports either or both IPv4 and IPv6 addressing modes, but
IPv6 is disabled by default.
• Wrong network settings may result in inaccessibility of your phone and may affect the
network performance. Contact your system administrator for the network parameters.

Basic Operations

Turning CP930W On/Off
To turn the CP930W on, do one of the following:
• Long tap , wait until the LCD screen lights up.
• Place the CP930W in the charging cradle. The CP930W will be turned on automatically.
To turn the CP930W off:
1. Long tap .
The LCD screen prompts you whether to power off the phone.
2. Tap the Yes soft key to continue.

Handset Settings

Handset Name
To rename the handset:
1. Tap Menu->Settings->Basic Settings->Phone Name.
2. Enter the value in the Phone Name field.
E
N
G
L
I
S
H
5