Startup; Switch The Monitor On And Off; No Signal; Select Input Signal - Eneo VM-UHD28M Schnellinstallationsanleitung

Startup

Switch the monitor ON and OFF

Connect the power cord to the monitor and the power source. Turn on the monitor using
the power button on the monitor or remote control. Press the power button again to turn
off the monitor.

No signal

If the monitor does not receive an input signal, this character is displayed:

Select input signal

Press the Source button on the remote control or the Mode button on the monitor to
select the input signal.
• Press ▼ ▲to select the correct input signal
• Confirm the selection with the Enter key on the remote control or with ► on the
monitor
EN
9