Kruger KRW 420 Bedienungshandbuch Seite 38

ENGLISH
• Fasten the bracket using the four supplied screws
S
Distance A: see Tab.2.
Setting up the brackets
The dehumidifier is supplied with two brackets to be installed on the air's holes on the side where the dehumidifier will be
installed. Use the brackets as a template for the holes, than use the supplied screws to secure them.
Dehumidifier Positioning
!
The machine must be lifted by at least two persons. To lift the machine do not touch in any way the tubes
of the refrigerating circuit, instead use the handle on the left side of the unit and the compressor plate on
the right side. Other points of the frame should be good for lifting, the important thing is to not exert
any force on the parts of the cooling circuit.
To position the dehumidifier follow the steps below:
• Lift the dehumidifier
• Carry it adjacent to the wall
• Pull the dehumidifier to the wall, so that the sheaths on the holes are deformed, and then let it go down slowly
• Check that the two brackets are positioned as on picture. The bracket on the dehumidifier is of the same length as the one
on the wall: the correct installation is that they don't protrude from either side between each other. This guarantees the
best holding and the centering of the air holes with the brackets.
• Regulate the frontal feet T to get the dehumidifier vertically set, being careful that the sheaths are adherent to the wall
mounted brackets
Clamping the dehumidifier
gb-38
M1100-0_draft-0