Philips HR6836/01 Gebrauchsanweisung Seite 7

16
To place a (new) dustbag:
- Press and hold the red lever when placing
the front plate into the holder (fig. 16).
- First position the bottom ridge (1). Then
press the top ridge into position (2) (fig. 17).
Ensure that the two notches on the front
plate point downwards and that the front
plate rests on the ridge of the holder.
18
- Slide the holder with dustbag into position
so that the holder is supported by the two
ridges in the container (fig. 18).
To remove a (full) dustbag:
- Lift the holder with the dustbag from the
container, holding the dustbag and the
holder by their handles (fig. 19).
20
- Press and hold the red lever to release the
front plate (fig. 20).
- Throw the used dustbag away
(fig. 21) and insert a new one.
Or, if you are using a cotton dustbag
(provided in some countries):
17
2
1
19
21
22
- Hold the dustbag over a dustbin (fig. 22).
- Remove the sealing clip by sliding it off the
dustbag sideways (fig. 23).
24
- Empty the dustbag into the dustbin (fig. 24).
- Close the dustbag by sliding the sealing clip
back onto the bottom edges of the dustbag
and put the dustbag back in place again
(fig. 25).
26
- Put the motor unit back on its place and
press the clamps to fix ("Click!") (fig. 26).
- Put the Micro-filter back on its place
(fig. 27).
28
- Pull the mains plug out of the appliance and
insert it into a wall socket (fig. 28).
- Switch the motor on (fig. 29).
8
23
25
27
29