Transmitting Status Of The Digital Inputs - Honeywell HX 85 Montage Und Bedienung

The operational test can now be performed for a maximum of
10 minutes.
Trigger a state change at the respective digital input or via the alarm
►
system at the respective device address.
If the state at the DI or device address A changes, the green LED
on the expansion module illuminates briefly, thus indicating that a
state change has been transmitted to the HCM 200D. The state
change for the sensors can be tracked via YES-NO switching in
the "Display/Sensor Values" menu at the HCM 200D.
In this context, also note the assignment to the respective
inputs (see Page 63).

Transmitting status of the digital inputs

The current status of the digital inputs can be transmitted with the
push of a button.
Press and hold the button on the HX 85 for approx. 2 seconds until
►
the green LED integrated in the button illuminates.
The status has been transmitted.
Transmitting status of the digital inputs
67