Additional Safety Rules For Tool - Makita 6905B Betriebsanleitung

15. Disconnect tools
When not in use, before servicing, and when
changing accessories such as blades, bits and
cutters.
16. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
17. Avoid unintentional starting
Don't carry plugged-in tool with finger on switch.
Be sure switch is off when plugging in.
18. Outdoor use extension cords
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
19. Stay alert
Watch what you are doing. Use common sense.
Do not operate tool when you are tired.
20. Check damaged parts
Before further use of the tool, a guard or other
part that is damaged should be carefully checked
to determine that it will operate properly and per-
form its intended function. Check for alignment of
moving parts, binding of moving parts, breakage
of parts, mounting, and any other conditions that
may affect its operation. A guard or other part
that is damaged should be properly repaired or
replaced by an authorized service center unless
otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by
and authorized service center. Do not use tool if
switch does not turn it on and off.
21. Warning
The use of any other accessory or attachment
other than recommended in this operating
instruction or the catalog may present a risk of
personal injury.
22. Have your tool repaired by an expert
This electric appliance is in accordance with the
relevant safety rules. Repairing of electric appli-
ances may be carried out only by experts other-
wise it may cause considerable danger for the
user.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Wear ear protectors.
2. Check the socket carefully for wear, cracks or
damage before installation.
3. Hold the tool firmly.
4. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
5. The proper tightening torque may differ
depending upon the kind or size of the bolt.
Check the torque with a torque wrench.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Holding the tool
Hold the tool firmly with one hand on the gripping
part of the tool and the other hand on the side grip
when performing the tool.
Selecting correct socket
Use a correct size socket for bolts and nuts. A wrong
size socket will result in inaccurate and inconsistent
tightening torque.
Installing the side grip (Fig. 1)
For 6906 only
Fit the side grip into the groove on the middle of the
hammer case and fasten securely.
Attaching the socket (Fig. 2)
Selecting a proper socket in size, please insert it into
the anvil so as to fix securely.
Switch action (Fig. 3)
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
• Change the direction of rotation only after the tool
comes to a complete stop. Changing it before the
tool stops may damage the tool.
The switch is reversible, providing either clockwise or
counterclockwise rotation. To start the tool, simply
pull the lower part of the switch for clockwise, the
upper part for counterclockwise. Release the switch
to stop.
5