Safety Notes; Setting Up And Connecting - IMG STAGELINE CALDERA-T6 Bedienungsanleitung

Active Speakers
These instructions are intended for users with
basic knowledge of PA technology . Please read
the instructions carefully prior to operation and
keep them for later reference .
1 Applications
This pair of high-quality active speakers is suit-
able for HiFi applications, as a monitor system
in home recording studios, as high-end PC
speakers, for AV presentations and for all other
applications in small to medium-sized rooms
where it is important to have a sound repro-
duction rich in detail . Each speaker system has
a 16 cm bass-midrange speaker with polypro-
pylene cone and a 2 .54 cm soft dome tweeter,
each controlled by separate power amplifiers .
The amplifiers are protected against short circuit
and overheating .

2 Safety Notes

The product corresponds to all relevant directives
of the EU and is therefore marked with
The product corresponds to all relevant UK
legislations and is therefore marked with UKCA .
WARNING The product uses dangerous
mains voltage . Leave servicing
to skilled personnel and do not
insert anything into the air vents!
Inexpert handling may result in electric shock .
•
The product is suitable for indoor use only .
Protect it against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
Do not place any vessels filled with liquid, e . g .
drinking glasses, on the product .
•
The heat produced inside the product must
be dissipated by air circulation; never cover
the air vents .
•
Do not use the product and immediately dis-
connect the mains plug from the socket
1 . if the product or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
product was dropped or suffered a similar
accident,
3 . if malfunctions occur .
Any repairs must be carried out by specialists .
6
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For cleaning the product, only use a dry, soft
cloth; never use water or chemicals .
•
No guarantee claims for the product and no
liability for any resulting personal damage
or material damage will be accepted if the
product is not correctly used or not expertly
repaired .
If the product is to be put out of opera-
tion definitively, dispose of the product
in accordance with local regulations .

3 Setting up and Connecting

Set up the speakers on a flat surface and align
them to the ears of the listener . The tweeters
should be at ear level if possible . Do not place
the speakers too close to walls or in corners; this
will distort the frequency response and impede
any heat dissipation of the integrated amplifier .
.
3.1 Connecting an audio source
To connect an audio source with line level
(e . g . CD player, mixer output, line output of
a computer), a 6 .3 mm jack (2) and an XLR
connector (3) are available which can be used
alternatively .
Both inputs are balanced . To connect audio
sources with unbalanced signals, use a 2-pole
6 .3 mm plug for the 6 .3 mm jack or a corre-
sponding adapter for the XLR connector (bridge
between pin 1 and pin 3) .
The contacts of both inputs are directly con-
nected to each other so that the second input
can also be used to forward the signal, e . g . to
another active speaker .
3.2 Power supply
For power supply, use the mains cable provided
to connect the IEC connector "230 V~/ 50 Hz"(5)
to a mains socket (230 V/ 50 Hz) .