3. Slide the receiver into the bracket with the 6-Pin in
circuit programing pins located vertically in the open end
of the bracket. Secure the receiver with a ¼" x 6" hex
head cap screw and a ¼" lock nut (See Figure 1-4).
TO
VIBRATOR
(Optional)
TO
PROGRAMMING
SPINNER
Figure 1-4
4. Plug the spreader spinner motor harness and vibrator
harness (optional) into the mating plugs on the receiver.
4 Cubic Foot Spreader
1. Remove the receiver bracket from the package and
place it under the top lip of the spreader hoper on the
driver's side (See Figure 1-5).
Figure 1-5
2. Secure the receiver by driving (2) 5/16" self-drilling
screws thru the holes in the bracket and into the hopper.
3. Slide the receiver into the bracket with the 6-Pin in
circuit programing pins located on the bottom. Secure the
receiver with (1) 1/4" x 6" hex head cap screw and (1)
1/4" lock nut (See Figure 1-6).
6
RECEIVER
PINS
TO TRUCK
- POWER IN
RECEIVER
BRACKET
4. Plug the spreader spinner motor harness and vibrator
harness (optional) into the mating plugs on the receiver
(See Figure 1-6).
RECEIVER
PROGRAMMING
PINS
TO
TRUCK -
POWER
IN
Figure 1-6
Control Harness Installation On Plow
1. Remove the wire harness components from the bag
of harness parts included in the control package.
2. Run the 4 wire harness on the receiver unit over to
the main power harness. Zip tie where necessary to the
main power harness. Ensure the control wire harness is
routed in the power harness clamp and continue running
with the main power harness. Leave enough room to
connect harness to vehicle harness. Ensure the cable is
clear of pinch points and latching mechanism. Any
excess cabling should be kept and zip tied under the
pump cover (See Figure 1-7 & 1-8).
MAIN
HARNESS
Figure 1-7
TO
VIBRATOR
(Optional)
TO
SPINNER