AEG X58263MV1 Gebrauchsanleitung Seite 5

5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
1 2
The electronic controls on your ducting
cooker hood have multiple
functions-features:
- Motor on-off function
The motor is turned on and off by
pressing pushbutton
on the cooker hood it automatically
starts running at the third speed. Nr. 6
speeds.
To select the required speed use
pushbuttons 2 and
setting is given on the display provided
for this purpose. It is possible to
modify these 6 speeds from intensive
mode "H" , display flashes, to normal
mode "L". To do this simply press
pushbutton 5 (LAMP) for five seconds.
When modifying speed mode the
cooker motor must be off.
- Timer function
This function permits you to program
your cooker hood so that the motor and
lights turn off automatically 10 minutes
after you have activated this function.
To program press pushbutton
the bottom on the right of the display a
point will flash indicating that the timer
function is activated.
- Lights on-off function
To turn the lights on and off press
pushbutton 5
- Specific features
The electronic controls provided
on your ducting cooker hood have
advanced features to facilitate
maintenance and correct utilization.
3 4 5
1 When you turn
3 . The speed
4 . At
- Prompt - clean metal filters
After every 40 hours of use a
microprocessor, heart of the system,
prompts the user that it is time to clean
the metal grease filters to guarantee
better ducting performance and to
improve hygiene. This prompt is
indicated by the letter "A" which flashes
on the display. To delete this prompt,
once the filters have been cleaned and
with the cooker hood off (not powered),
maintain pushbutton
for more 14 than 5 seconds. When
you press this pushbutton the letter
"A" will come up on the display and
then disappear after 5 seconds. The
microprocessor
zeros the number of hours and starts
a new count from zero until reaching
40 hours prompting this maintenance
procedure.
- Prompt - replace active carbon filters
(if mounted)
If your cooker hood utilizes the re
circulation air filtering system and
therefore is fitted out with active carbon
filters for purifying the vapors extracted,
it is necessary that you program the
microprocessor for this extraction
system. To do this, always with the
cooker hood off (not powered),
maintain pushbutton
seconds. The symbol " –" will come
up on the display (this indicates the
cooker hood is not provided with a
carbon filter) and after 5 seconds this
symbol changes to "C" (now indicating
the cooker hood is provided with a
carbon filter). After every 80 hours of
use the microprocessor will prompt the
user to replace the carbon filter. This
prompt is indicated by the letter "C"
which flashes on the display. This is to
guarantee better filtering performance
and to improve hygiene. To delete
this prompt, once the filters have been
replaced and with the cooker hood off
(not powered), maintain pushbutton
3 pressed for more than 5 seconds.
When you press this pushbutton the
letter "C" will come up on the display
and then disappear after 5 seconds.
The microprocessor zeros the number
of hours and starts a new count from
zero until reaching 80 hours prompting
this maintenance procedure.
ENGLISH 5
2 pressed
4 pressed for 5