SATO DR308e Kurzanleitung Seite 21

5 From the ribbon supply spindle, pass the carbon ribbon underneath the thermal head to the
ribbon take-up spindle.
Tape the end of the carbon ribbon to the ribbon core, and then wind the ribbon around the core several times in the direction of
the arrow.
Confirm that the ribbon has been loaded as shown in the figure below when viewed from the side.
Figure showing the paper and ribbon path
CAUTION
• The thermal head and the surrounding area will become hot immediately after a printing operation. Take
care not to burn yourself if you need to replace the carbon ribbon immediately after a printing operation.
• Touching the edge of the thermal head with your bare hands may result in injury.
Ribbon
Paper
21