Sinbo SSI 2869 Bedienungsanleitung Seite 8

first time. After a short while, this will cease.
2. Before using for the fist time, remove any sticker or protective foil from the soleplate. Clean the
soleplate with a soft cloth.
3. Keep the soleplate smooth: avoid hard contact with metal objects.
Component Name
A. Spray Nozzle
B. Water Filling Opening
C. Steam Control Knob
D. Burst of Steam Button
E. Spray Button
F. Power Cord Protector
G. Indicator light
H. Water Tank
I. Thermostat Dial
J. Sole plate
K. Skirt
Filling with Water:
Make sure iron is unplugged and the thermostat dial is in the MIN position. Place iron on the heel rest,
tilt forward approximately 45 angle and pour water into the water-filling opening to the MAX position
of the water tank.
Vertical Steam
"Burst of Steam" can also be applied when holding the iron in vertical position, this is useful for removing
creases from hanging clothes, curtains ,etc.
Dry Ironing
1. Set the steam control button to position O(=No Steam)
2. As per washing label of various clothes, set the correct ironing temperature to begin a ironing.
Steam Ironing
1. Fill water in the iron as per the water-filling methods.
2. Plug the appliance in the socket.
3. If only set thermostat dial to MAX position as per the temperature indicator, steam iron will be
available, otherwise water may leak from the soleplate.
4. It indicates that the temperature has been ready until the indicator light goes off.
5. Set the steam control button correctly, increase steam output by turning the steam control button
back and decrease steam output by forward.
Caution: Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use the steam iron, otherwise it will
damage the finish of surface.
Burst of Steam
This function works well for tough wrinkles and heavy fabrics. By pressing "Burst of Steam" button,
an intense burst of steam is emitted from the soleplate, this can be very useful when removing stubborn
creases. The shot of steam facility can be used only while ironing with high ironing temperature. For
optimal result, there should be 5 seconds rest between presses of the steam button. To prevent leaking
water from the soleplate does not press the steam button continuously for more than 5 seconds. Also
allow at least one minute interval before applying this burst of steam function.
- 7 -