Sinbo SSI 2869 Bedienungsanleitung Seite 10

Simple Repair Methods
Problem
Not enough heat or Too
heat
No steam or Leakage
No burst of steam or no
vertical steam
Leaking water from
Soleplate
Little Steam
No Spraying
Possible Reasons
Rotate thermostat dial improperly
or unplugging
The thermostat dial has been set to
MIN
The (vertical) burst of steam
function has been used too often
within a very short period. The iron
is not hot enough
Set the thermostat dial out of steam
range.
The heat is still not enough.
The water is over than max position Pour out the remaining water
Check if the steam control button
is in proper location.
Steam hole is blocked.
Too little water in the water tank
No enough pressure or air inside
- 9 -
Measurement
Correct Thermostat dial in position
and check if the iron is plugged.
Set the thermostat dial to the
required position.
Continue ironing in horizontal
position and wait a while before
using the (vertical) burst of steam
function again
Set the thermostat dial as per steam
range.
Open steam control button only after
the indicator light goes off.
Set the steam control button to the
proper location.
Clean hole with distilled water.
Fill water into the box
Press the spray nozzle by hand,
and push the spray button several
times continuously.