Cleaning The Air Filter; Cutter Plates - Aesculap Econom II Gebrauchsanweisung

9. Removing the cutter head
Unplug the machine before removing the cutter head!
Remove both screws 6. Then turn the cutter head very slightly
(about 15°) counterclockwise. The cutter head can now be removed
from the motor (see fig.).
The cutter head should be carefully re-attached to the motor after
it has been thoroughly cleaned and its gear wheel has been lightly
greased (see section 6). When re-attaching the cutter head, it
should be turned 15° counterclockwise in such a way that its lower
flange engages with the groove of the motor housing.

10. Cleaning the air filter

The two air filters attached at the rear of the motor should be
removed daily for hand-cleaning or cleaning with a suitable tool
such as a screwdriver. The air filters should be thoroughly cleaned
with a brush in warm water.
After drying, the air filters should be re-attached to the machine,
which should be cleaned beforehand.
Important
Clean the air filters frequently in order to ensure that the motor is
adequately air-cooled during operation.
Under no circumstances should the machine be run without an air
filter!
11. Maintenance and repairs
During shearing season, the cutter head should be cleaned every few
days.
To do this, remove the cutter head from the motor housing (see
section 9)
Then remove the cutter plates (see section 7) and both housing
screws 11 (see fig.).
Use only a soft cleaning brush or paintbrush to give the interior
surfaces of the cutter head and other unit components a thorough
cleaning.
After carefully reassembling the machine, the cutter head should
be greased according to the instructions in section 5.
In order to avoid damaging the unit, we recommend that you
contact your dealer, who can supply you with replacement parts,
and can also repair your machine properly.
Before any work is done on the machine, it should always be
unplugged!
8
Sheep shearing machine GT494 and cutter head GT369
12. Service addresses
Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone: +49 (0) 8086 933-100
Fax: +49 (0) 8086 933-500
E-mail: info@kerbl.com
www.kerbl.com
Other service addresses can be obtained from the address indicated
above.
13. Storage
Store the machine and the cutter plates (which should be oiled) on
an absolutely clean and dry surface.

14. Cutter plates

Cutter plates compatible with cutter head GT369
GT578
GT588
GT594
15. 2 Year Warranty
Dear Customer,
Thank you for choosing a product from our company.
For decades, the name Aesculap has stood for proven quality and first-
class service. We are known to provide innovative, high-performance
products for our customers. Aesculap manufactures high-quality
devices, using high-quality materials and careful manufacturing
processes. We would like to point out to you that we are not liable for
defects in our products, if these are caused by improper use, normal
wear or are caused by the product being improperly used or if
inappropriate or not properly functioning third-party products are
used.
Parts that are typically subject to wear, and for which we are therefore
not liable, are the battery and clipper head. Defects that do not affect
or only negligibly affect the value or function of the product are also
excluded from our warranty.
If we are liable under our warranty, we reserve the right to repair or
replace the product.
Upper cutter plate with four cutting teeth
Lower cutter plate with 13 cutting teeth, 3.5 mm thick
Lower cutter plate with 13 cutting teeth, with outer
teeth curved outwards