Maintenance And Storage; Warranty Conditions - MARIMEX ProStar Balls Bedienungsanleitung

EN
Assembling filtration
When compiling filtration, follow the figures 1-6. Place the dirt collector in the
middle of the container. Fill the 550g Marimex Balls filter cartridge. Place the
seal on the bottom of the lid. The seals must be clean, free from dirt. Carefully
return the lid to the container. Close and tighten the buckle again. Connect the
pump and the rest of the filter with the connection hose and hose clamps. We
recommend that the joints be covered with Teflon tape for greater leakage.
Teflon tape is not included. Connecting the filtration with the pool - the opening
in the lid - connect to the pool outlet - through this hole the water from the pool
returns to the filtration. Pump in the pump - Connect to the pool entrance, ie the
skimmer (the skimmer is not included) - Through this hole, the water from the
pool flows into the filtration to clean it.
Filtration operation
Make sure that the filter is not plugged into the mains. Check that all hoses and
joints are tightened. Make sure the filtration is located below the water level. Allow
all filtration to flood. Use a clear lid valve to vent the filter until the water starts to
flow. Now, filtering is ready for power and startup. Swimming pool water should
flow through the pump at least 3-5 times over 24 hours, depending on system load
and size. The time required depends on the capacity of the filter device and the size
of the pool. If the pool is used intensively or when the pool is unusually heavy, it is
necessary to extend the operating time. Regularly check for contamination of the
filter cartridge. If necessary, replace or refill the machine up to 30 ° C.

Maintenance and storage

Only use original spare parts. Before winter, disconnect the filter, drain the water,
let it dry. Alternatively, you can clean with conventional means. Do not use abrasi-
ves or solvents. After cleaning it does not want to dry. Store in a dry and tempera-
te environment where the filtration is protected from frost.

Warranty conditions

Filtration was made of high quality material. All parts have been inspected and
found to be safe, the warranty is valid for 24 months from the date of purchase.
Keep all purchase documents together with the instructions. Proof of purcha-
se will be required when applying warranty claims. Complaints of goods are
governed by the Czech legal order. The warranty covers all defects caused by
manufacturing faults or material defects. We recommend that you review its
completeness when purchasing the product. After the filtration purchase, we
recommend that the integrity of the packaging and filtering or other degradation
be checked. In case of any damage, please inform the dealer immediately. If the
filter shows obvious defects that occur immediately after commissioning and for
which equipment can not be used, defects must be applied by the buyer to the
seller without undue delay. When defect is detected on the individual parts of the
filter, complain only the faulty part. The filter device can be installed and opera-
ted according to the instructions in this manual.
20