B) Holding The Microscope; C) Focus The Microscope; D) High And Low Magnification; E) Digital Zoom - TOOLCRAFT MOBILE Bedienungsanleitung

b) Holding the Microscope

c) Focus the Microscope

• Direct the lens (A2) over the object and adjust the LED brightness (A10).
• Adjust the fine focus dial (A9) to bring the image into sharp focus.
It may take a few moments for the white balance to auto adjust and bring the image into focus. If there is
too much reflection from the object, consider lowering the LED brightness (A10) or turning it off completely.

d) High and Low Magnification

• Center the lens (A2) over the object.
• High magnification: Turn the fine focus dial (A9) all the way to the right, then slowly dial back until the image comes
into focus.
• Low magnification: Turn the fine focus dial (A9) all the way to the left, then slowly dial back until the image comes
into focus.
After turning the fine focus dial (A9) all the way right or left, it will take a few seconds for the LED light
balance to adjust.

e) Digital Zoom

• First bring the object into focus on the LCD display (A19).
• Zoom in or out of the object by adjusting the digital zoom

f) Photo / Video Capture

• Press to switch between photo and video modes
- An icon on the LCD display (A19) indicates that you are in Photo mode.
- An icon on the LCD display (A19) indicates that you are in Video mode.
• Press the image capture button
• If recording a video, press the image capture button
Hold your wrist with your left hand to help prevent camera shake.
• Hold the microscope in your right hand and adjust the
angle of the LCD display panel (A19) so it is in line with
your vision.
• Use your left hand to access any controls that cannot be
reached with your thumb.
to take photo or begin recording video.
again to stop recording.
(A7).
35