Standalone Configuration With A Web Browser - e:cue ETH2DALI Installationsanleitung

7.2

Standalone configuration with a web browser

To use a wired connection to a PC, connect this ETH2DALI to an Ethernet switch, connect a PC to
the same switch. In the web browser enter http://192.168.123.1 as web address to access the
ETH2DALI in factory state.
PC
ETH2DALI
RJ45 Cat5
RJ45 Cat5
Ethernet switch
Mobile device
ETH2DALI
iOS
Android
RJ45 Cat5
WLAN access point
During initial setup you can only use a web browser. The Mobile Action Pad
i
can only be used with a completely configured and programmed ETH2DALI.
After connecting and booting the ETH2DALI you
will see the entry page:
The entry page does not allow changes in the
configuration, but shows the current settings and
information.
To change the configuration you will need the
password to get the configuration page. The default
password is "ecue". Click Configure and enter the
password. This will bring you to the page for the
basic system parameters.
In Cuelist Settings the number of stores cuelists on
the micro SDcard is displayed. In DALI Settings the
connected, identified or missing DALI ballast are
displayed. Mismatched ballast have an unidentified
short address.
The Info section contains logging messages,
system messages and error messages. These
messages can only be viewed, or the specific part
of the information section can be cleared. After en-
tering the configuration password, you can change
the basic system parameters of the ETH2DALI:
ETH2DALI: Configuration - Standalone configuration with a web browser
To use a wireless connection to a mobile device,
ETH2DALI to a WLAN access point. In the web browser of the mobile
device, enter http://192.168.123.1 as web address to access the
ETH2DALI in factory state.
If you do not reach the device, the IP address is not in factory state.
Reset the ETH2DALI. Use an Ethernet switch, not a cross cable.
connect the
17