e:cue ETH2DALI Installationsanleitung Seite 15

ETH2DALI: Configuration - Online configuration
The Group ID is used for clustering standalone engines. If used only online, leave the Group ID as
it is. The Config Password is used, when the ETH2DALI is configured standalone with a web
browser. The default password is "ecue".
Do not change parameters in the Advanced Setup,
unless advised to do so. These parameters set timing
and behavior for the DMX and DALI communication.
OK
Close the dialog with .
Start the Device Manager of the Programmer and
execute the Automatic Device Setup Wizard. The
ETH2DALI will be found and displayed as three devices
for DALI, DMX and digital inputs/relays outputs
(terminals).
Double-click on the DALI device to set the parameters
for the DALI interface.
The parameters Enable Driver and Private Logbook
are common to all dialogs. You can enable/disable the
device and a separated log book in the Programmer.
Give the device a unique alias name. A comment helps
to identify the device in the Device Manager and in the
system.
The Export parameters are usually assigned
when exporting a show from the Programmer
to the engine for standalone mode. You can
also enable or disable the daylight saving time
adjustment and the use of a web browser with
OK
this ETH2DALI. Close the dialog with .
15