e:cue ETH2DALI Installationsanleitung Seite 16

ETH2DALI: Configuration - Online configuration
Double-click on the Terminal device. This defines the inputs and relays.
Leave the Trigger Events enabled to receive
Triggers in the Programmer. With the Outputs
section you can set or clear the relay state in the
ETH2DALI during startup. The relay state is also
signalled by the LEDs in the ETH2DALI.
OK Cancel
Click to close the dialog or to abort
configuration. Next, the DMX section of the
ETH2DALI can be configured.
Double-click on the DMX device of the ETH2DALI
in the Device Manager.
ETH2DALI supports one DMX universe. The only
necessary parameter to set here is the assigned
DMX universe number.
Again, use unique and speaking names for your
devices to simplify the identification of devices in
the Programmer. Click OK to assign values, Cancel
to abort configuration. Close the device manager.
The ETH2DALI is configured completely.
16