Beper LOT 2013-120 Betriebsanleitung Seite 20

Arm blood pressure monitor Use Instructions
Testing
1. Power On
Press and hold " ON/OFF " button until a beep sounds. The LCD screen will appear for one second
as unit performs a quick diagnosis. A long tone indicates device is ready for testing.
Note: Unit will not function if residual air from previous testing is present in cuff.
The LCD will flash until pressure is stabilized
2. Pressurization
Initial pressure is first pumped to 190 mmHg. If the current user's systolic blood pressure is over
190mmHg, the unit will automatically re-inflate to the proper shelf.
Note: Pressurization will gradually subside and ultimately stop when cuff is not properly applied to the
arm. If this occurs, press " ON/OFF "button to turn the unit off.
3. Testing
After cuff inflation, air will slowly subside as indicated by the corresponding cuff pressure value. A
flashing will appear simultaneously on screen signaling heart beat detection.
Note: Keep relaxed during testing. Avoid speaking or moving body parts.
4. Result Display
Three short beeps sound when testing is complete. The screen will display measurements for systolic
and diastolic blood pressure. A indicator representing the current measurement will appear next to the
corresponding WHO Classification.
Note: Refer to Page 23~24 for detail WHO Blood Pressure Classification Information.
Irregular Heartbeat Indicator
If the monitor detects an irregular heart rhythm two or more times during the measuring process, the
Irregular Heartbeat Symbol appears on screen along with measurement results. Irregular heartbeat
rhythm is defined as rhythm that is either 25%
slower or faster than the average rhythm detected while measuring systolic blood pressure and dia-
stolic blood pressure. Consult your physician if the Irregular Heartbeat Symbol frequently appears
with your test results.
5. Deleting/Storing Test Results
User may delete their current test result due to unfavorable testing conditions or for any other reason.
To delete the last test result, press the "SET" button after result is displayed.
If result is not deleted, it will automatically store by date within the previously configured Memory
Group.
Note: Be sure the appropriate Memory Group selection is made prior to testing.
If the number of tests surpasses the allotted 60 memories per group, the most recent tests will appear
first, thus eliminating the oldest readings.
Power Off
The " ON/OFF " button can be pressed to turn off the unit in any mode. The unit can turn off the power
itself about 3 minutes no operation in any mode.
20