Maintenance; Maintenance Schedule - Husqvarna LC 247 Bedienungsanweisung

CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
• Make sure that the ignition cable is connected to the
spark plug.
Manual start (not on LC 347VI, LC 353VI)
1. For LC 247, LC 247S: The very first time you start
the product, press the primer bulb 5 times. The next
time you start the product when the engine is cold,
press the primer bulb 3 times.
2. Stay behind the product.
3. Hold the engine brake handle against the handlebar.
(Fig. 35 )
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING: Do not twist the starter rope
around your hand.
Electrical start (LC 347VI, LC 353VI)
1. Make sure that the battery is activated and charged.
To start the battery on page 14 .
See
2. Attach the battery to the engine.(Fig. 36 )
3. Push the start inhibitor out to the right (A).
4. Pull the start bar (B) against the handlebar to start
the starter motor. The starter motor stops when the
engine starts.(Fig. 37 )
To use the drive on the wheels
• For LC 247S, LC 247SP: Pull the drive bail in the
direction of the handlebar.(Fig. 38 )
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
12
• For LC 347V, LC 347VI, LC 353V, LC 353VI: Start
the drive on the wheels with the speed control lever
on the left side of the handle. Move the speed
control lever forward to increase the speed and
rearward to decrease the speed.(Fig. 39 )
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10 cm.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the engine, release the engine brake handle.
To remove the battery
To prevent accidental start of the engine, remove the
battery on model LC 347VI, LC 353VI when the product
is not in operation.
1. Press the lock buttons (A) and pull the battery out.
(Fig. 40 )
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.

Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance marked with * see instructions in
Safety devices on the product on page 9 .
WARNING: For model LC 347VI, LC 353VI,
always remove the battery before you do
maintenance, repairs or clean the product.
808 - 002 - 19.06.2018