Installing The Ribbon Cassette - Epson TM-H5000II Bedienungsanleitung

Removing the Dampers
1
Using the Power Switch Cover
WARNING:
If an accident occurs with the power switch
cover attached, unplug the power cord
immediately. Continued use may cause
fire.
The enclosed power switch cover keeps
the power switch from being pressed
accidentally. To use the cover, install it
as shown in illustration

Installing the Ribbon Cassette

Use the EPSON ERC-31 ribbon cassette. The use of any ribbon
cassettes other than those approved by Epson may damage the
printer and will void the warranty.
CAUTION:
Never turn the ribbon cassette's feed knob in the opposite direction of
the arrow marked on the cassette; otherwise the ribbon cassette may
be damaged.
1. Turn the printer on, and open the front cover by pulling up the
tab on the left side.
2. Be sure the print head is on the right side.
3. If a ribbon is already installed, remove it by grasping the end of
the tab and removing it from the printer.
The printer is protected for shipping by
two transportation dampers that you
must remove before you turn on the
printer.
Open the printer by pulling the tab on
the front cover, and remove the two
dampers shown in illustration
Note:
Reinstall the dampers before shipping.
.
2
TM-H5000II User's Manual 7
English
.
1
2