Mounting Instructions - Wenglor SD4RAS01SN89 Betriebsanleitung

EN

5. Mounting Instructions

• During fitting, the requirements of ISO 14119 must be observed.
• Safety switch and actuator must be permanently fitted to the safety guards and protected against
displacement by suitable measures (tamperproof screws, gluing, drilling out screw heads, pinning).
• The universal mounting holes provide for a variable mounting by means of M4 screws (tightening torque:
2.2 ... 2.5 Nm).
• Any mounting position.
• The labelled surfaces of the safety switch and the actuator have to be opposite.
• The safety switch must only be used within the assured switching distances ≤ S
To avoid any interference inherent to this kind of system and any reduction of the switching distances, please
observe the following guidelines:
• The presence of metal chips in the vicinity of the sensor is liable to modify the switching distance.
• Keep away from metal chips.
• Minimum clearance between two safety switches or to other systems of the same frequency (125 kHz):
100 mm
30
and ≥ S
.
ao ar
min.
100 mm
Mounting Instructions