Herunterladen Inhalt Inhalt Diese Seite drucken

Störungen - Oase Aquamax 4.000 Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für Aquamax 4.000:
Inhaltsverzeichnis

Werbung

D
Achtung! Wenn Sie die Pumpe in der Filterschale unter Wasser betreiben, muss immer der Satellitenfilter
(bzw. Skimmer) am Einlassregler angeschlossen oder der Einlassregler ganz geschlossen (Stellung „0") sein!
Zum Ausschalten des Gerätes Netzstecker ziehen.
Reinigung
Achtung! Vor Reinigungs-und Wartungsarbeiten immer den Netzstecker ziehen!
Entfernen Sie die Schläuche vom Gerät. Die Einrastpunkte an beiden Seiten der Auslassöffnung zum Wasserfilter ein-
drücken und die Filterschale öffnen, die Pumpe aus der Filterschale nehmen, den Einlassregler aus seiner Führung ent-
fernen, das Pumpengehäuse abdrehen, das Laufrad mit einer Bürste reinigen.
Achtung! Öffnen Sie das auf keinen Fall Motorgehäuse! Falls der Rotor ersetzt werden muss oder der
Motor defekt ist, wenden Sie sich an Ihren Fachhändler.
Filterschalen, Schlauchtüllen, Satellitenfilter und Einlassregler mit klarem Wasser und einer Bürste reinigen. Montieren
Sie das Gerät nach erfolgter Reinigung in umgekehrter Reihenfolge.
Lagern/Überwintern
Das Gerät ist frostsicher bis minus 20 °C. Sollten Sie das Gerät außerhalb des Teiches lagern, führen Sie eine gründliche
Reinigung durch, prüfen Sie es auf Beschädigung und bewahren es getaucht oder befüllt auf. Den Netzstecker nicht ins
Wasser tauchen!
Entsorgung
Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen. Fragen Sie Ihren Fachhändler.
Störungen
Störung
Gerät läuft nicht
Wasserlauf ungenügend
Gerät schaltet nach
kurzer Laufzeit ab
GB
Information about this operating manual
Please read the operating instructions and familiarise yourself with the unit prior to using it for the first time. Adhere to the
safety information for the correct and safe use of the unit.
Intended use
The Aquamax 4000 – 16000 series has been exclusively produced for pumping normal pond water for filters, waterfalls
and watercourses; its use is intended for water temperatures between 4°C and +35°C and an operating voltage of
230 Volt. The unit is frost proof.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and in the case of
misuse. If used for purposes other than that intended, our warranty and operating permit will become null and void
CE Manufacturer's Declaration
We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low voltage directive
(73/23/EEC). The following harmonised standards apply: EN 60335-1, EN 60335-2-41, EN 55014-2,
EN 61000-3-2, EN 61000-3-3
Safety information
OASE has manufactured this unit according to the highest quality standards and the valid safety regulations. In spite of
the above, hazards for persons and assets can emanate from this unit if it is used in an improper manner or not in
accordance with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons who cannot recognise
possible danger or who are not familiar with these operating instructions, are not permitted to use the unit!
Please keep these operating instructions in a safe place! Also hand over the operating instructions when passing the unit
on to a new owner. Ensure that all work with this unit is only carried out in accordance with these instructions.
The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly connected and
misused. Only use the unit if no persons are in the water! Prior to reaching into the water, always disconnect the power
supply of all units used in the water. Compare the electrical values of the power supply with those on the type plate on
the packaging or on the unit itself. Ensure that the unit is fused for a rated residual current of max. 30 mA via a residual
current-operating system. Only operate the unit when plugged into a correctly fitted socket. Keep the power plug and all
connection points dry! Protect the connection cable when burying to avoid damage. Only use cables, equipment,
adapters, extension or connection cables with an earthed contact and approved for outside use. Do not carry or pull the
6
Ursache
- Netzspannung fehlt
- Laufrad blockiert
- Filterschale/Satellitenfilter verschmutzt
- Schlauch verstopft
- Schlauch geknickt
- Zu hohe Verluste in den Schlauchleitungen
- Filterschale verstopft
Abhilfe
- Netzspannung überprüfen
- Reinigen
- Reinigen
- Reinigen, ev. ersetzen
- Schlauch prüfen, ev. ersetzen
- Schlauchlänge auf nötiges Minimum reduzieren
- Reinigen
Signature:

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis