Using The Adf - Plustek SmartOffice PL1530 Benutzerhandbuch

U s i n g t h e A D F
U s i n g t h e A D F
1. Load the documents, headfirst and face down, toward the center of the ADF
paper chute and all the way into the ADF until touching the bottom.
For single-sided scans, load the documents face down so that the side to be
scanned faces towards the paper chute.
For double-sided scans, load the desired page order of documents face down
so that the side to be scanned faces towards the paper chute.
2. Adjust the paper width slider for the paper size you are using. The paper width
slider should be gently touching both sides of the documents.
Attention
DO NOT load more than 50 sheets of paper
2
(70 g/m , 18 lb.) to the ADF.
Paper scanned from the ADF must be a
minimum of 9 x 5.08 cm (3.55" x 2", W x L).
Make sure there are no gaps between the
document stack and the paper-width slider;
otherwise, the scanned images can be
skewed.
Although the documents should be loaded
firmly in place ensuring optimum scanning
accuracy, they should never be wedged in so
tightly that the process of feeding them
through the scanner is strained.
Do not load additional paper into the ADF
18