Schneider Schirme Barbados Montage- Und Bedienungsanleitung Seite 42

EN
Assembly
Place the two elements of the cross base (A + B) one on top of the other as
shown and screw firmly to the tube (C).
Use the screws M8x25 (D) and one washer (E) for each screw.
NOTE:
The tube slants backwards at an angle of 3°.
This is intentional and is not grounds for
complaint.
The slanted design of the tube prevents
the pole from hanging forward when the
umbrella is open and also gives the
umbrella an overall elegant appearance.
Now put the assembled cross base at the location where the umbrella is to
be set up. Make sure the ground underneath is solid and level.
Now insert 4 paving slabs in the cross base.
IMPORTANT:
Always use all four paving slabs with a size of 50 x 50 cm!
Never use the umbrella stand without paving slabs.
Now place the cover (F) on the cross base as shown.
42