Klarstein 10031893 Anleitung Seite 22

EN
22
SET-UP
Water, mixed with a suitable carpet shampoo solution, is pumped deep into the fibres
of the carpet via the shampoo application nozzle. The dirty liquid is then sucked back
into the waste tank along with the dirt and grime dislodged by the cleaning solution.
Water can be pumped up to 2 meters above the machine so that stairs may also be
shampooed.
Carpet Cleaning
1 Ensure the machine is unplugged from the power supply.
2 Fit the foam filter.
3 Reposition the head onto the tank body and clip in place.
4 Ensure that the shampoo solution has been mixed with the recommended
proportion of water and pour it into the shampoo tank. Insert the shampoo tank
connecting tube and filter into the tank and push the cap onto the tank filler neck to
avoid any shampoo splashing out whilst working.
5 Plug the nozzle on the other end of the shampoo tank connecting tube into the
shampoo inlet hole on the rear of the motor housing.
6 Ensure that the transparent shampoo delivery tube is fitted correctly around the
suction hose and held in place with the clips provided.
7 Screw the large threaded connector on the end of the flexible suction hose to the
vacuum inlet on the front of the tank.
8 Push the connector on the end of the shampoo delivery tube into the shampoo outlet
nozzle on the front of the motor housing.
9 Slide the spraying trigger fitting into the mount at the top of the plastic tube. Push
gently and ensure it clicks into place. Fit the large washing head to the plastic tube.
Connect the shampoo delivery tube from the head to the trigger. The black fitting is
a push and twist fit.
10 The spraying nozzle at the other end of the delivery tube is a push fit into the
mounting on the underside of the head. There is a notch in the nozzle which must fit
onto a spigot in the head mounting to ensure that the nozzle outlet is the right way
round. NOTE: To clean fabrics and upholstery, clip the spray nozzle with the short
tube into the underside of the small cleaning head. Then attach the trigger directly to
the mounting on the underside of the small head. Push the assembled head onto the
air diffuser handle. Note: The metal plastic tube is not used.
1 1 Select the switch to position [I], to operate the pump for shampoo application only.
Select the switch to position [II], for simultaneous shampoo application and dirty
liquid suction. Squeeze the trigger to apply shampoo to the area to be washed.
Large Cleaning Head Small Cleaning Head