Playing Back Notes; Searching For A Note Automatically (Auto-Scan) - AUDIOLINE VR-C10 Bedienungsanleitung

PLAYING BACK NOTES

Make sure that the HOLD slide switch is in the OFF position (slide switch
down).
Press the PLAY/STOP button to switch the unit on.
Now select the required message using the
The number of the note will be shown in the display.
The note can be played back by pressing the PLAY/STOP
button.
You can interrupt the playback with the PAUSE button and
then continue with the PAUSE or PLAY/STOP button. If
playback is interrupted for more than 10 minutes, playback
will be terminated automatically.
Press the PLAY/STOP button again to terminate playback.
The volume can be adjusted in 20 steps by means of the VOL. – and VOL. +
buttons on the right-hand side.
During playback:
If you want to fast forward or fast rewind within a long note, hold the
multifunction button pressed until you reach the required position.
While you are listening to a note, you can switch automatically to the previous
or next note. To do this, simply press the multifunction buttons
(forward) briefly.

SEARCHING FOR A NOTE AUTOMATICALLY (AUTO-SCAN)

If you want to search for a particular note, you can use the SCAN function. With this
function, only the first 5 seconds of the note are played back in each case before
changing automatically to the next note.
To do this, press the PLAY/STOP button for two seconds. The display will
show SCAN. The SCAN function always starts from the currently selected note
number.
When you have found the right message, press the PLAY/STOP button again
to listen to this note in full.
20
or multifunction button.
or
(rewind) or