Connecting The Charging Station - AUDIOLINE WAVE 10X Bedienungsanleitung

Putting the Telephone into Operation

Connecting the charging station

Connect the charging station as
illustrated in the diagram. For
safety reasons, only use the
power adapter plug supplied.
Inserting the batteries
Insert the batteries in the open battery
compartment. Only use batteries of
the type AAA NiMH 1,2 V.
Pay attention to correct polarity.
Close the battery compartment.
Charging the batteries
When the handset is inserted in the base/charging station properly,
you will hear an acoustic confirmation signal and the charge control
lamp lights up. The handset warms up during the charging process.
This is normal and does not represent a risk. Do not charge the
handset with charging units from other manufacturers. The current
battery charge status is indicated in the display:
Only applies to telephone sets with at least two handsets .
1
Section Package contents" on Page 23.
24
Service−Hotline Germany: Tel. 0180 5 001388 (cost via Telekom at time of going to print: 14 ct/min)
9
Before the handset is used for the first time, insert it in the
base/charging station for at least 24 hours.
Full Half empty
1
Mains power outlet
Low Empty