Finishing The Installation - D-Link DUB-A2 Anleitung

A. Remove the outer cover of your computer. Refer to your computer manual as needed.
Remove the backplate (the small piece of metal that covers the opening for the PCI card).
B. Locate an available PCI slot and insert the DUB-A2 carefully into the PCI slot.
C. Secure the DUB-A2 with the screw from the backplate. Replace your computer's cover and
plug in the power cord.

Finishing the Installation

The following steps are only applicable if your system is running Windows XP without a Service
Pack installed or under Windows 98SE/ME/2000. Install the latest Windows XP Service Pack
on your computer for optimal product performance. Driver installation will proceed
automatically for Windows XP users with a Service Pack installed. If Service Packs are not
installed or under Windows 98SE/ME/2000, follow these steps to complete the driver
installation:
A. Power on the computer.
B. Windows will detect new hardware and prompt you for the drivers, which can be found on
the CD provided. Please follow onscreen instructions.
installation, please refer to the manual on the CD.
C. If prompted to restart (under Windows ME and Windows 98 only), click Yes.
Troubleshooting
1. If I've lost my CD, what can I do?
The CD contains software drivers and manual that can also be obtained from D-Link
website (see Technical Support below).
2. Why are the devices connected to the DUB-A2 not functioning properly?
• When connecting the USB cable to the computer, make sure that the USB cable is
inserted securely.
• Remember that when connecting USB 1.0 or USB 1.1 products into a USB 2.0 adapter,
the USB 1.x product will not work faster.
• To ensure optimal performance when using USB 2.0 devices, use a USB 2.0 certified
cable.
Technical Support
Thank you for choosing D-Link products. For further information, support and product manuals
please visit the D-Link website at www.dlink.eu.
www.dlink.co.uk
: 08456 12 0003
2
For detailed instructions on driver