General Information - Saro EB 26 Betriebsanleitung

GENERAL INFORMATION

• Before the first start-up, read these operating instructions carefully and observe the information
given therein.
• Keep these operating instructions within easy reach, near the device.
• The manufacturer/dealer cannot be held responsible for damage caused by non-observance of these
operating instructions.
• If these operating instructions are not observed, the safety of the device is no longer guaranteed.
If the device is passed on to third parties, these operating instructions must be supplied with the
device.
• This equipment must not be operated by children or persons with reduced physical, sensory
or mental abilities, as they cannot recognize the dangers of using electrical appliances and/or
refrigerators and as accidents, fires, explosions or damage to property may occur.
• Do not use the device outdoors in rain or in wet rooms.
• After unpacking the device, make sure that everything is in perfect condition. If you discover any
damage, do not connect the device but contact your dealer.
• Check that all components listed in the scope of delivery are present. If this is not the case, contact
your dealer.
• Keep the unit's packaging. The device can only be transported safely in its original packaging.
• Please note that all components of the packaging (plastic bags, cardboard, polystyrene parts, etc.)
may endanger children and must therefore not be stored near them.
• If it is not possible to store the packaging, separate the various packaging materials and return them
to the nearest collection point for proper disposal.
• Place the unit in a dry and adequately ventilated place.
• Ensure a distance of at least 15 cm between the back of the ice cube maker and the wall. Otherwise,
the desired cooling capacity can no longer be guaranteed.
• Do not place the unit near heat sources such as heating, stove, oven or open fire or in direct sunlight
as the desired cooling capacity can no longer be guaranteed.
• The ventilation slots must always be kept clear and must not be covered or closed.
• Before connecting the device to the power supply and putting it into operation, clean the device
thoroughly.
• Do not drill or pierce holes in the inside or outside of the unit. The cooling circuit could be damaged.
• The ice cube container is foamed in and thus well insulated. This reduces melting of the ice cubes.
• The device is neither suitable nor intended for the storage of medicines or highly inflammable,
flammable or explosive substances.
• Subject to technical modifications and errors excepted.
Stand 12/2012 WBS / 10/2018 TM
23