Grundig GBP 7000 3D Bedienungsanleitung Seite 37

INFORMATION
TV screen and video
The images from this player
do not appear on the tele-
vision.
Picture is distorted.
Video is not output in high-
definition.
The 4:3 aspect ratio picture
expands left and right.
When it is playing BD-LIVE
disc, Video output is a
black screen.
Internet
Desired WLAN network not
found.
Connection to router not
established.
Sound
No sound. Low volume.
Distorted sound.
Cannot hear the desired
audio type.
Cannot switch dubbed lan-
guage or the audio format .
------------------------------------------------------------------------------------------------------------------
Make sure that the LED/LCD-TV is connected to the VIDEO OUT so-
cket or HDMI OUT socket on this device.
Make sure that the LED/LCD-TVs input setting (e.g., VIDEO 1) is correct.
The device is likely to enter screen saver status.
Try to reset the device. To do so, press "
then press this button again.
High definition video cannot be output through the VIDEO OUT.
Confirm that the HDMI Resolution in the Setup menu is set properly.
Use the LED/LCD-TV to change the aspect. Refer to your LED/LCD-TVs
operating instructions.
Insert a USB memory stick with a free space. Select BD-Live Storage
from the BD-Live Menulist. Then restart the device.
Please check the internet is available or not. Some of the disc need the
support of internet.
Please check the connection cable to the router. If it is loose, please
insert again.
– WLAN network is deactivated, switch on the WLAN network.
– SSID is suppressed on the router; display SSID on the router.
– Distance to router is too large; reduce distance to router.
– MAC adress of the device is not enabled on the router;
enable MAC address on the router.
– Data transfer from the router is encrypted; Enter the network key
(WEP orWPA) on the device.
If this does not help, check the entire router configuration.
Check the connections and the "Digital Output" settings. Check the
input mode on the amplifier/receiver if you have connected one.
Press »AUDIO« to select the audio signal.
The sound effects (Re-master, V. Surround, etc.) will not work when the
bitstream signal is output from the HDMI OUT socket or the
»COAXIAL« socket.
When "BD-Video Secondary Audio" is set to "Off", Dolby Digital
Plus, and Dolby TrueHD are output from the »COAXIAL« terminal as
Dolby Digital or DTS Digital Surround bitstream.
Try to reset the device. To do so, press "
then press this button again.
There are discs for which audio cannot be changed because of how
the disc was created.
When connecting an amplifier/receiver using a coaxial cable or an
HDMI cable, you cannot switch the audio if "Digital Output" is set to
"Bitstream". Set "Digital Output" to "PCM" or connect using audio
cables.
8 ", wait for 5 seconds and
8 ", wait for 5 seconds and
ENGLISH
37