Set-Up And Safety - Grundig GBP 7000 3D Bedienungsanleitung

SET-UP AND SAFETY

Please note the following instructions when set-
ting up the system:
The device is designed for the playback of
7
video and audio signals from compact discs,
USB and similar data devices. Any other use is
expressly prohibited.
If you want to set up the device on wall shelves
7
or in cupboards, please ensure that it is ad-
equately ventilated. There must be at least 10
cm of space at the side, above and behind the
device.
Do not cover the device with newspapers,
7
table cloths, curtains, etc.
When setting up the device, remember that
7
furniture is often coated with various types of
varnish and plastic, which often contain chemi-
cal additives. These additives may cause cor-
rosion to the feet of the unit. This may leave
stains on the surface of the furniture which can
be difficult or impossible to remove.
If the device is exposed to sudden changes in
7
temperature, for example when taken from the
cold into a warm room, wait at least two hours
before using it.
The device is designed for use indoors. If you
7
use it outdoors, make sure it is protected from
moisture such as dripping or splashing water.
Use the device only in a moderate climate.
7
Do not place the device close to heating units
7
or in direct sunlight, as this will impair cooling.
Do not place any vessels containing liquids,
7
such as vases, on the device. Do not insert any
foreign objects in the disc compartment.
Do not place any objects such as burning can-
7
dles on the device.
Do not open the device casing under any cir-
7
cumstances. Warranty claims are excluded for
damage resulting from improper handling.
Thunderstorms are a danger to all electrical
7
devices. Even if the device is switched off, it
can be damaged by a lightning strike to the
mains. Always disconnect the mains plug dur-
ing a storm.
-----------------------------------------------------------------------------------------------
Always keep the disc compartment closed to
7
prevent dust from collecting on the laser optics.
Do not use cleaning agents as they may dam-
7
age the housing. Clean the device with a
clean and dry cloth.
Notes:
Do not connect any other equipment while
7
the device is switched on. Switch off the oth-
er devices as well before connecting them.
Only plug the device into the mains socket
7
after you have connected the external de-
vices. Make sure the power plug is freely
accessible.
3
ENGLISH