Maintenance And Cleaning; Protective Measures; Wear Parts - Oase LUNAQUA 3 Gebrauchsanleitung

- EN -

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
• Ensure that no moisture can enter the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft brush.
Replacing the glass or coloured glass and the bulb
 C
Undo the screw connections at the mounting plate for nozzle holder, then remove residual water. Ensure that no mois-
ture can enter the unit. Screw off the union nut, remove the glass or coloured glass and the O ring, check for damage,
replace, if necessary, then remove the bulb from the housing.
Important! Only original bulbs from OASE may be used.
Insert new bulb (do not touch, use a cloth or similar). Reassemble the unit in the reverse order, connect to the power
supply and perform a function check.

Wear parts

Bulbs are wearing parts and are excluded from the warranty.
Repair
Neither the transformer nor the spotlight can be repaired in the event of damage to the cables or the housing and must,
therefore, be replaced.
Disposal
Note
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided
for this purpose.
10