Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After cleaning, snap the shaving unit back
6
onto the appliance ('click') (Fig. 19).
Cleaning the trimming unit
Remove the trimming comb by sliding it off
7
the appliance.
Push the middle part of the trimming
8
unit upwards with your thumb until
it opens (Fig. 20).
Remove hairs from the hair chamber with
9
the cleaning brush and/or with lukewarm
water. (Fig. 21)
Rinse the trimming unit with lukewarm
10
water (Fig. 22).
After cleaning, close the trimming unit
11
and reattach the trimming comb. (Fig. 23)
Replacement
In case of frequent use, replace the shaving unit
(type number TT2000) every year. Replace a
damaged shaving unit immediately. To replace the
shaving unit:
Pull the shaving unit off the
1
appliance. (Fig. 16)
Snap the new shaving unit onto the appliance
2
('click') (Fig. 19).
storage
You can fold the charger for easy travelling or
storage. To fold the charger:
Fold the base of the charger against the
1
appliance holder (Fig. 24).
Environment
-
Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 25).
-
The built-in rechargeable battery contains
substances that may pollute the environment.
Always remove the battery before you
discard and hand in the appliance at an official
collection point. Dispose of the battery at an
official collection point for batteries. If you have
trouble removing the battery, you can also take
the appliance to a Philips service centre. The
staff of this centre will remove the battery for
you and will dispose of it in an environmentally
safe way. (Fig. 26)
Removing the rechargeable battery
Take the appliance out of the charger and let
1
the motor run until the battery is completely
empty.
Remove the front panel from the appliance
2
with a screwdriver (Fig. 27).
Undo the four screws of the cover under the
3
front panel with a screwdriver. (Fig. 28)
Use a screwdriver to break open the cover
4
and remove it. (Fig. 29)
Now you see the printed-circuit board
,
to which the rechargeable battery is
attached (Fig. 30).
Lift the printed-circuit board with
5
rechargeable battery out of the
appliance (Fig. 31).
Cut the wires to separate the printed-circuit
6
board and the rechargeable battery from the
appliance (Fig. 32).
3
guarantee and service
If you need service or information or if you have a
problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If
there is no Consumer Care Centre in your country,
go to your local Philips dealer.
guarantee restrictions
The shaving unit is not covered by the terms of
the international guarantee because it is subject to
wear.
4222.002.8048.1
Werbung
