Function Information - Beko ATH8130 Bedienungsanleitung

3

Function information

On/O Humidi cation mode Heat humidi cation Humidity Timer
1. On/Off
After connecting the machine to power, the buzzer makes harmonious rings for four times with the
whole LED screen flickering once, and the machine is now in power-on state.
Press On/Off, the machine enters into standard humidification mode. The buzzer makes harmonious
rings for four times, and the indicator light is on. Current humidity will be shown on the LED screen.
The humidity default is 88-77-66-55-44-33-22-11..
The first ten minutes after startup is preheating time for humidity sensor.
If the machine is in heat humidification or turbo status, motor will delay by 1 min to be standby.
2. Humidification mode
There are 4 humidification modes, i.e. sleep humidification mode, standard humidification mode,
intensive humidification mode and smart humidification mode. Please see the figure for LED screen
display.
The electric motor and thermal fuse are connected to humidification function. (Motor: 220V/50Hz,
rated power 30W; Thermal fuse: rated power 250W)
Sleep humidification mode : The motor operates at 700rpm. The display screen only shows .
When the humidity is 5% over the set point, the machine will enter into standby mode. When the
humidity is 5% below the set point, it will reenter into sleep humidification mode.
Standard humidification mode : The motor operates at 1000rpm. When the humidity is 5% over
the set point, the machine will enter into standby mode. When the humidity is 5% below the set point,
it will reenter into standard humidification mode.
Intensive humidification mode : The motor operates at full power. The heating power is 250W.
When the humidity is 5% over the set point, heating will stop, and also the motor will enter into
standby mode after 1 minute. When the humidity is 5% below the set point, it will reenter into
intensive humidification mode.
8 / 28 EN
Evaporation humidifier / User Manual