Beko ATH8130 Bedienungsanleitung Seite 22

6 Cleaning and maintenance
Clean the water wheel components.
• F or daily cleaning: Wash the water wheel in clean water.
• F or cleaning stubborn dirt, soak it in warm water containing neutral detergent for 30 minutes or
so, and use water to clean it for 2 or 3 times. Make sure the detergent is of neutral nature. Alkaline
detergent may cause deformation and reduce the performance.
• I f the machine has special dirt or it has not been washed for a long time, we recommend that
you dismount the humidification plate of the wheel for easy cleaning. See following figures for
disassembly.
- Use cross screwdriver to disconnect the fastening screws (a in the figure).
- Pull out wheel gear (b in the figure).
- Dismount back cover of wheel (c in the figure).
- Dismount the humidification plates piece by piece (d in the figure).
- Installation procedures are as follows:
- Install the humidification plates piece by piece (d in the figure) and press tight;
- Install the back cover of wheel (c in the figure);
- Install the wheel gear (b in the figure) and press tight;
- Use cross screwdriver to screw tight the fastening screws (a in the figure); and
- In the end, put the installed wheel components into the trough.
22 / 28 EN
Evaporation humidifier / User Manual