Lightmaxx CLS Laser System FX Bedienungsanleitung Seite 19

Installation:
Always check the device for damage before use. Use the original packaging or suitable trans-
port or storage packaging to protect the product optimally from infl uences such as dust or
moisture, etc. when not in use.
The device can be installed either standing or hanging. The mounting must always be done
on a solid support or an stable surface. Use the opening of the brackets to attach the device.
Always create a second, separate safeguard for the device, e.g. by means of a safety.
All work on the device (e.g. installation) should always be carried out on a stable and platform.
Make sure that the area below you is closed off.
Please note that the use of this device with a dimmer is not possible!
19
Note! (Operating conditions)
Due to its structural characteristics, the device is designed for indoor use.
Do not expose the device to rain, moisture or liquids, as this can cause
damage. Vibrations, dirt or sunlight can also lead to damage, avoid them!
Warning! (Power Supply)
Make sure that the device voltage matches your local mains voltage. It
is strongly recommended to protect your mains socket with a residual
current circuit breaker (RCD).
If you do not use your device for a longer period, disconnect the device
from the mains to minimize risks. The same applies to thunderstorms or
fl oods, etc.
Warning! (Falling hazard)
It must be ensured that the device complies with all legal standards and
regulations in the respective country of use. Ensure that the device is
always secured by a second mounting cable (e.g. Safety).
Warning! (Overheating)
The maximum permissible ambient temperature of this device is 40° C.
Ensure that the unit is always adequately ventilated.