Hilti ST 1800 Original Bedienungsanleitung Seite 18

5.1.3 Removing the depth gauge
CAUTION
Risk of injury The depth gauge may hinder the operator if fitted but not used.
▶ Remove the depth gauge from the tool.
1. Remove the protective sleeve.
2. Pull the depth gauge forward, away from the power tool.
5.1.4 Changing the bit
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Remove the depth gauge. → page 14
2. Pull the sleeve back and hold it securely.
3. Change the bit.
4. Release the sleeve and allow it to slide forward.
5. Fit the depth gauge. → page 13
5.1.5 Adjusting the depth gauge
5.1.5.1 Screw sealing washer compressed too much
If the screw sealing washer is compressed too much, turn the depth gauge to the right.
5.1.5.2 Screw sealing washer is not compressed enough
If the screw sealing washer is not compressed enough, turn the depth gauge to the left.
5.2 Types of work
Warning! Risk of damage!
▶ Operation of the direction of rotation and/or function selector switch while the tool is running may
result in damage to the tool.
▶ Do not operate this switch while the tool is running.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Switching on
Note
Press the control switch slowly all the way.
▶ Press the control switch slowly all the way.
5.2.2 Activating continuous running mode
1. Press the control switch.
2. Press the lockbutton.
3. To switch off when in continuous running mode, press the control switch.
◁ The lockbutton returns to its original position.
5.2.3 Setting the torque
▶ Turn the adjusting ring to the desired torque setting.
5.2.4 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired position.
14 English
Printed: 05.04.2017 | Doc-Nr: PUB / 5070703 / 000 / 04
3
4
2