Hilti ST 1800 Original Bedienungsanleitung Seite 17

Chuck
Protection class
4.1 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintenance of the electric tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise information
Sound power level (L
pA
Sound pressure level (L
Uncertainty
Vibration information
Triaxial vibration value
Uncertainty (K)
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the scaffold hook
1. Push the scaffold hook onto the tool from the front.
2. Turn scaffold hook into the desired position.
3. Secure the scaffold hook by tightening the knurled thumb screw.
4. Check that the scaffold hook is fitted securely.
5.1.2 Fitting the depth gauge
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable
and, at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Remove the protective sleeve.
2. Fit the depth gauge.
Printed: 05.04.2017 | Doc-Nr: PUB / 5070703 / 000 / 04
)
)
wA
3
ST 1800
/ " hex socket
1
4
II
84 dB
95 dB
3 dB
2.5 m/s²
1.5 m/s²
English 13