hi-Fun hi-bomb 2 Bedienungsanleitung Seite 14

Switch on hi-Bomb2 Bluetooth®.
To switch on hi-Bomb2 Bluetooth® hold the button until
transparent fins turns on and hi-Bomb2 Bluetooth® emits 4
acustic tones. Afterwards hi-Edo automatically connects itself
to the last paired device, if available, and the warning LED
flash slowly in blue to confirm the connection. If there is no
available paired device or if it is out of range, hi-Bomb2
Bluetooth® turns off in about 7 minutes in order to prevent
battery from discharging.
Pair hi-Bomb2 Bluetooth® with a compatible
device.
To pair for the first time, pair for a second time or to pair to a
different device, hi-Edo must be set in pairing mode, signaled
by the transparent fins flashing alternately and quickly red and
blue. To activate the pairing mode you need to switch off hi-
Bomb2 Bluetooth® and switch it on again holding the button
until the transparent fins flash alternately red and blue. Now
you can select hi-Bomb2 Bluetooth® from the list of found
devices on your device. As soon as the device is paired, the
transparent fins flash slowly blue.
Now it is possible to listen to music and to make calls* through
hi-Bomb2 Bluetooth® (*thanks to the integrated microphone).
It is also possible to pair hi-Bomb2 Bluetooth® to 2 devices
at the same time. To do this, pair the first device as explained
before, then repeat this step with another devices. At this point
the two paired devices could be connected at the same time
and priority is assigned to the last device that start streaming