Kenwood BLP60 Bedienungsanleitung Seite 6

key
filler cap
lid
vents
goblet
sealing ring
blade unit
blade base
power unit
Power On indicator
speed + pulse control
TYPE BLM61 & BLP61 only
Programme buttons
drinks
ice crush
rinse
Multi mill (if supplied)
multi mill jar
grinding mill (if supplied)
mill lid
grinding mill blade assembly
grating mill (if supplied)
mill lid
grating mill blade assembly
to use your blender
1 Fit the sealing ring
blade unit
located correctly in the grooved
area.
G
Leaking will occur if the seal
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto
the goblet – ensuring the blade
assembly is fully tightened
Refer to the graphics on the
underside of the blade unit as
follows:
- unlocked position
- locked position
4 Put your ingredients into the
goblet.
5 Fit the filler cap to the lid and push
down to secure.
6 Fit the lid by pushing down until
secure.
into the
- ensuring the seal is
into the base
.
7 Place the blender onto the power
unit .
G
The appliance will not work
if the blender is incorrectly
fitted.
8 Plug in and the indicator light will
remain unlit whilst in the "O" OFF
position.
TYPE BLM60 & BLP60 - Turn
the speed control to select a
speed (refer to the recommended
usage chart).
G
Select a speed between 'Min' to
'Max' by turning the speed control.
At the end of blending return the
speed control to "O" OFF before
removing the blender.
G
Do not remove the goblet until the
blades have stopped rotating and
the speed control is in the "O" OFF
position.
G
(P) Pulse – operates the motor in a
start/stop action. The pulse will
operate for as long as it is held in
position.
Note: If the blender is removed
from the power unit whilst a speed
is selected the Indicator light will
go out and the blender will stop.
The blender willl restart
immediately if refitted.
TYPE BLM61 & BLP61 only -
Turn to the "on" position and the
Power On indicator
pre-programmed buttons will light
up.
Note: In the "on" position the
Power On indicator will flash if the
goblet is not fitted to the power
unit.
In the "O" OFF position all the
indicator lights will remain off.
9 Select a speed (refer to the
recommended usage chart).
Choose one of the following
options:
6
and the 3