REV Ritter F-688D Bedienungsanleitung Seite 5

GB
General information
Please thoroughly read the following operating instructions before placing the device
into service and keep for future reference. The bell button is suitable for operation in
protected outdoor areas and not in harsh environments. The wireless chime is intended for
installation in dry indoor areas (IP20).
Installation may only be carried out by a qualified electrician!
Notes
• The wireless chime is only designed for use with the appropriate batteries.
• This wireless chime set consists of a transmitter and a receiver.
• This wireless chime set offers you the possibility to set up a bell system without wiring.
• This set is not intended for integration into an existing bell system.
• The range between transmitter and receiver is maximum 50m in the open field. The radio signal
is transmitted through walls, walls, furniture and other obstacles, but depends on the structural
conditions - walls, especially reinforced concrete walls, heat-insulating glazing and ceilings lead to a
reduction in range.
• Shielding caused by metal parts can severely impair reception, so that the signal cannot be transmitted.
For this reason, never attach the transmitter to metal surfaces.
• If the product is not in use for a long period of time, remove the batteries.
• The product has no replaceable parts. Do not try to open or repair the product.
Technical Data
Type:
Range (free field)
Frequency:
Frequency band:
Max. transmission power:
Battery:
Degree of protection:
Volume:
Number of melodies:
Standby consumption:
Mode:
Degree of protection:
F-688D
max. 50m
433,92MHz
433,05 – 434,79MHz
<10mW
Receiver: 3x 1,5V LR03 (AAA) (not included in delivery)
Transmitter: 1x 3V CR2032 (included in delivery)
Receiver: IP20 (for dry indoor use only)
Transmitter: IP44 (protected outdoor area)
25-125dB (4-stage adjustable)
58 melodies for selection
Gong: <5mA
Sound + flash (fixed)
Only sound
Only flash
Sound + continuous light (can be used as night light)
Safety Extra Low Voltage