G21 RAZOR Handbuch Seite 6

Using the unit
Stretch out both
and insert them all the way
in. The unit starts to run
automatically.
Self-check indicator
When a malfunction or error occurs, the self-check indicator on the right side will either light up
or flash.
Turn off the power switch, wait about 40 seconds until all the indicators go off, then turn on the
power switch.
If the indicator still lights up or flashes, turn of the power, disconnect the unit from the socket, and
contact your dealer immediately.
When using the unit
Turn on the power switch.
The power indicator lights up.
The lamp lights up.
The cover of power supply is closed.
Cleaning the unit body
Clean the unit with a soft cloth. If the unit gets very dirty, clean with a soft cloth dampened with
neutral agent, then clean with a dry soft cloth.
Remove the dirt from the sensor (to prevent malfunction).
Note
Only use the neutral cleaning agents.
Do not use thinner, accidic or alkaline toilet cleaners, or nylon brush. (Otherwise, they may damage
the smoothness of surface).
Only use alcohol to clean the hans drying area. (Do not use alcohol anywhere else).
If the chemical cloths used, please read their instructions first.
Disinfecting agents will damage your unit.
Warning
Before you clean the unit, turn off the power switch.
Do not splatter water on the unit.
Caution
Wear gloves when cleaning.
The antibacterial coating becomes not effective when the surfaces get very dirty.
hands Pull them out slowly, letting
the air blow the water off.
Pull them out completely.