G21 RAZOR Handbuch Seite 10

Precautions before installing
Do not install in the following types of location, otherwise this may cause malfunction:
• Locations where the temperature can exceed -10 C or 40 C.
• Locations where the unit may come into direct contact with water.
• Locations where the unit is under direct or strong sunlight.
• Locations where there is a lot of condensation.
• Locations where corrosive, neutral, or reductive gases are present.
• Places lower than -20m or hig her than 2000m above sea level.
Installation location:
• Install the unit somewhere, where it will be easy to use, as shown in the figure. If the unit is in-
stalled too low, water may get on it when the floor is being cleaned. (The bottom of the unit must
be at least 150 mm higher than the floor or any objects under it.)
• The left side of the unit must be at least 150 mm away from any walls, because the power switch
is located on the left.
• Ensure there are no mirrors or walls near the right side, as drops of water may splatter to the
right when drying hands. (Recommended distance is at least 100 mm.)
• Avoid locations where people or doors might bump into the unit.
• Choose a completely flat surface on the wall to install the unit.
Installation base:
• If your space is limited and the condition of wall is unsatisfactory, you can purchase an installa-
tion base to install the unit.
1. Fixing screw
2. The mounting screw holes
3. Machine hanging hole
4. Wall screw into position
1
2
3
4