Epson Perfection 610 Benutzerhandbuch Seite 107

EPSON Perfection 610
Operating
conditions Ordinary office or home conditions; avoid
extreme dust, direct sunlight, and strong
light sources. Make sure the outlet
provides enough power.
Safety Approvals
120 V model
Safety standards UL 1950 with D3
CSA C22.2 No. 950
EMC FCC part 15 subpart B class B
230 V model
Safety standards EN 60950
EMC EN 55022 (CISPR Pub 22) class B
CE marking
230 V model Low Voltage Directive 73/23/EEC
EN 60950
EMC Directive 89/336/EEC
EN 55022 Class B
EN 61000-3-2
EN 61000-3-3
EN 50082-1
USB Interface
Interface type Universal Serial Bus Specification
Revision 1.0
Configuration
Element Description
Configuration Characteristics: Self-powered
Remote wake up feature: Not supported
Maximum power consumption from
VBUS: 2mA (5V)
Interface No alternate setting
Number of endpoints used by this interface
(excluding endpoint 0): 2
Class: Vendor specific
Endpoint 1 Bulk IN transfer
Maximum data transfer size: 64 byte
Endpoint 2 Bulk OUT transfer
Maximum data transfer size: 64 byte
String Descriptor Language ID: US English
1: iManufacturer: "EPSON"
2: iProduct: "Perfection610"
2 - EPSON Perfection 610
CSA C108.8 class B
AS/NZS 3548 class B
IEC 801-2
IEC 801-3
IEC 801-4
Electrical standard Full Speed mode (12Mbit/s) of
Universal Serial Bus Specification
Revision 1.0.
Connector type One receptacle (series B)
Connector pin arrangement
Pin number
1
2
3
4
Initialization
methods The scanner can be initialized (returned to
a fixed set of conditions) in the following
ways:
Hardware * The scanner is plugged in.
initialization * The USB cable is unplugged from the USB port
on the scanner.
Software * Software sends the ESC @ (initialize the scanner)
initialization command.
* The scanner receives a Bus Reset from the USB
interface.
Lamp and Button
The scanner lamp acts as an indicator and the scanner has one
button. Lamp status and button function are described in the
tables below.
7/99
Signal Connector
VCC
–
DATA
+DATA
GND
scanner lamp
Start button